Temperature Selection; Room Temperature; Safety Measures - Vitek VT-1186 Manual Instruction

THERMOPOT VT-1186
An electric thermopot is intended for boiling water
and maintaining the required temperature of water.
DESCRIPTION
Minimal water level mark
1.
Water level scale
2.
Water dispense on button
3.
Spout for pouring water
4.
Control panel
5.
Lid opening button
6.
Steam release openings
7.
Removable upper lid
8.
Lid lock
9.
Carrying handle
10.
Body
11.
Power cord connector
12.
Rotary base
13.
Control panel
Timer activation indicator «TIMER»
14.
Timer setting button «TIMER»
15.
Water boiling mode indicator «BOILING»
16.
Repeat boiling button «REBOIL»
17.
Water temperature selection button
18.
«TEMPERATURE SELECTION»
Room temperature mode indicator
19.
«ROOM TEMPERATURE»
Water dispensing lock indicator « »
20.
Water dispensing unlock button «UNLOCK»
21.
Maintained temperature indicator «40°C-55°C-
22.
65°C-75°C-85°C-95°C»
Display
23.
Water dispensing button «DISPENSE»
24.
Power cord
25.
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal opera-
tion current not exceeding 30 mA, to install RCD,
contact a specialist.

SAFETY MEASURES

•
Before using the electric thermopot, read this
instruction manual carefully.
•
Make sure that the operating voltage of the unit
corresponds to the voltage of your mains.
•
The power cord is equipped with a «euro plug»;
plug it into the socket with reliable grounding
contact.
•
To avoid fire, do not use adapters for plugging
the unit in.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
•
When unplugging the unit, always pull the plug
but not the cord.
•
Never leave the operating unit unattended.
•
Do not switch the thermopot on if it is empty.
•
Do not drop or tilt the unit.
•
Use the thermopot only for water boiling; it is
prohibited to heat or boil other liquids in it.
•
Ensure that water level in the thermopot is not
below the minimal mark and not above the max-
imal mark.
•
Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a suit-
able bowl.
•
Place the thermopot on a flat dry and stable sur-
face; do not place the thermopot on the edge of
the table.
•
Do not place the thermopot next to the walls or
close to the kitchen furniture.
•
Place the thermopot keeping at least 20 cm gap
between the thermopot body and the wall and at
least 50 cm gap above the thermopot.
•
Do not use the unit near heat sources or open
fire.
•
Do not let the power cord hang from the edge of
the table and make sure it does not touch hot or
sharp edges of furniture.
•
Do not open the lid and do not pour water out
during boiling.
•
Do not rotate the unit during water pouring.
•
Do not apply excessive effort when closing the
lid. When using the thermopot, make sure that
the lid is closed tightly.
•
Keep your hands away and do not bend over the
steam release openings, it may cause burns.
Do not block the steam release opening with
any objects.
•
Do not touch hot surfaces of the thermopot.
•
Be careful while carrying the thermopot filled
with boiling water.
•
Do not carry the thermopot holding it by the lid
opening button.
•
Be careful when pouring out hot water.
•
Remove the lid before draining the remaining hot
water from the thermopot flask.
9
ENGLISH