Table of Contents
Advertisement
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and
receive information from the vehicle. The Control Module
transmits High Frequency FM signals from the vehicle to your
over long distances. Your range will vary depending on
location, terrain, and local RF noise/interference.
system is not guaranteed to page you if you are behind
concrete walls, underground, in a large structure, or in an
area with high levels of electronic interference. Handle the
pager/remote with care if the LCD display and/or the
electronics may be damaged if subjected to abuse. The AAA
Cell 1.5V alkaline battery can easily be replaced by sliding
open the battery access door on the back of the remote.
Battery life will vary depending on usage. The LCD screen
will display a low battery icon when the battery is low. For
more on range, see "Range Questions" on page 18.
QUICK CHART
Button
Button Functions
Lock Doors & Arm System
Unlock
Doors
System
Trunk Release (Aux # 1)
Aux #2
Start or Stop engine
2-car operation (Side Button)
(Change from Car 1 to Car
2) or Car 2 to Car 1
TRANSCEIVER / PAGER-REMOTE
Button Options
Press
and
Hold
seconds
Activate "Panic" feature
&
Disarm
Press twice for second door
unlock
Press and Release for Aux
#1
Press and Hold button # 2 &
# 3 for 3 sec.
Press
and
Hold
seconds
Press and Hold for 3 seconds
Press 5 times to Disable/Enable audible beep tones from the remote
Press and Release to Recall the last message from the LCD screen
This
#5
RECALL /
CAR I OR II
#1 ARM/
LOCK
#3 TRUNK
POP
Buttons
for
3
Aux#3
Aux #4
Car Jack
(See page 14)
Silent Arm/Disarm
for
2
3
FIXED
ANTENNA
PM
Button Functions
Button Options
Press Button #1 and #4 at
the same time
Press Button #3 and #4 at
the same time
Press Button #1 and #3 at
the same time
Press Button #2 and #4 at
the same time
LCD
SCREEN
#2 DISARM/
UNLOCK
#4 ENGINE
START/STOP
Advertisement
Table of Contents
