Transceiver / Remote Control Programming - CrimeStopper SP-500 Operating Instructions Manual

TRANSCEIVER / REMOTE CONTROL PROGRAMMING

Note: All transmitter codes must be learned at time of programming!! The SP-500 learns up to 4
different transmitter codes.
1. Turn key to the ON position. (Pink wire must be connected.)
2. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
3. Press button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting
nd
for a 2 code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting
rd
for the 3 code and so on. If all 4 codes are learned, the unit will automatically exit code learning mode,
otherwise turn key off. See diagram below.
OFF
PRESS LOCK
IGN
PRESS 4X's
FLASH 2, 3, or 4 X's
OFF
16
WAIT FOR
4 FLASHES
IGN
COMPLETE