Setting The Clock And Beep Or Vibrate Selection; Using The 2-Way Pager - CrimeStopper PS01-G5 Operating Instructions Manual

The 2-Way LCD Pager remote transceiver is used to send and receive information from the vehicle. The
Control Module transmits High Frequency FM signals from the vehicle to your pager over long distances. Your
range will vary depending on location, terrain, and local RF noise/interference. This system is not guaranteed to
page you if you are behind concrete walls, underground, in a large structure, or in an area with high levels of
electronic interference. Handle the pager/remote with care. The LCD display and/or the electronics may be
damaged if subjected to abuse.
The 2-Way LCD remote has a battery charge indicator on top right corner of display. The battery voltage affects the
distance of the remote control. The system comes with a standard Mini USB charging cable that plugs into the side
of remote control. To access to USB plug, slide the cover to the left shown below.
1. Press VEH Button on the side of the remote control 5 times.
2. The remote will beep and the AM or PM display will begin flashing.
3. Press the Trunk Button to go to the next item – AM - PM - Hour- Minutes.
4. Press the Lock Button to Increase time.
5. Press the Unlock Button to decrease time.
6. Press the Start Button to Disable or Enable Beep and Vibration. See next page.
7. Press the VEH Button to Save and Exit Setup or wait 8 seconds, the LCD light will turn off.
USING THE 2-WAY PAGER TRANSMITTER
BATTERY CHARGING
SETTING THE CLOCK (2-WAY- LCD REMOTE)
6
USB Charging Port