Unpacking - Halcro Eclipse mono Owner's Manual

Unpacking

Before installing your Halco Eclipse, ensure you have
read the Important Safety Information section on
page 3, and have also familiarised yourself with the
Controls and Connections section on page 12.
If you require assistance in the unpacking and
installation of your Halcro amplifier, please contact
your dealer.
It is advisable to remove rings or other jewelry and
avoid wearing clothing or belts with metal fittings to
prevent scratching the product.
When moving the amplifier itself it is recommended
that you and your assistant wear the white gloves
provided to prevent marking the amplifier.
The protective fabric coverings are intended to be
removed from the foot first and then the top. Be
sure never to overbalance the amplifier during this
process.
NOTE: When lifting the unit, always
use two people.
The unit is best lifted by placing your
hands under the middle of the top
compartment.
The unpacking procedure
o Being careful to avoid contact with the
amplifier, unlatch and remove the top section
of the flight case
o With an assistant lift the amplifier from the
base of the container and carefully lower it to
the ground
o Remove the protective fabric from the side
pillars or legs of the amplifier:
o
Ensuring the amplifier does not over
balance, have one person carefully tilt
the amplifier so that one foot is lifted
from the ground by no more than 1 inch
(30 mm)
o
Ensure that your hands are never
underneath the foot. While the foot is off
the ground grasp the fabric at the sides
of the foot, pull down and away from the
amplifier so that it is clear of the foot.
Lower the unit carefully back to the
ground
o
Lift the fabric from the top of the pillar
and retain future use
o
Repeat this process for the other leg
o Move the unit to its final location (see
Positioning below)
10