Setup - Halcro Eclipse mono Owner's Manual

Setup

Do not connect to mains power until all
other connections have been securely
made.
The basic setup procedure is as follows:
1. Place the amplifier in its final position
2. Connect the cables (excluding mains)
3. Connect mains power cable
4. Read the Operation section
5. Enjoy!
Positioning
We suggest that the Halcro amplifiers be positioned
as near to your loudspeakers as practical. This will
reduce the length of the loudspeaker cable required.
The sides of the unit house the heat sinks that are
used to dissipate heat. The airflow to these should
not be interrupted. Ensure there is at least 12 inches
(300 mm) clearance around the unit.
During set up ensure there is room to kneel and work
behind the unit before moving it to its final position.
Connecting the loudspeakers
There may be high voltages present
at the loudspeaker terminals,
which may present an electric
shock hazard if touched. Always
ensure the unit is switched to OFF
or Standby mode when connecting
or disconnecting loudspeakers.
The Eclipse mono has four loudspeaker terminals,
allowing for bi-wiring (p12, fig B, ④).
o 2 x positive + (red bezel)
o 2 x negative - (black bezel)
All of the solid, pure copper connections are finished
with the highest-grade gold plating.
o Ensure the positive terminal of the amplifier
connects to the positive terminal of the
loudspeaker to ensure correct phasing of the
audio signal
o The loudspeaker terminals will accept banana
or spade connectors. Only fully insulated
connectors should be used
o Ensure the loudspeaker terminals are securely
tightened, but do not over tighten or you may
damage the terminals
o When connecting loudspeaker cables always
ensure the conductive surfaces are not
touching each other.
DO NOT SHORT-CIRCUIT THE TERMINALS
16