Care And Maintenance - Halcro Eclipse mono Owner's Manual

Care and Maintenance

The Eclipse mono amplifiers have been designed for
indoor use only. Under no circumstances should the
amplifier be allowed to get wet. The only
maintenance required is to ensure the unit is kept
clean.
Cleaning
Halcro takes no responsibility for any damage
caused through careless or improper cleaning
techniques.
WARNING: Never use flammable
products when cleaning the Eclipse
mono.
The outer surface of the unit is
painted and will be marked if
rubbed with an abrasive cloth.
Please read the following procedures very carefully:
o Disconnect the amplifier from the mains
power before cleaning
o Use an extremely soft dry cloth to remove any
dust, particularly from the heat-sink area
o Add 15 ml (0.5 oz) of very mild household
dishwashing detergent to a four-liter (one-
gallon) bucket of tepid water
o Immerse the soft cloth in the bucket of water
and then wring the cloth out thoroughly until
the cloth is nearly dry
o Use the slightly damp cloth only to clean the
painted surfaces and timber feet
o Never clean any electrical fittings, terminals or
the front and rear labels with the damp cloth
o No moisture should ever be allowed to enter
the amplifier's compartments through the
joins in the panels
o After using the slightly damp cloth, wipe over
the surfaces with a soft dry cloth
o Clean the labels using an extremely soft
polishing cloth, which must be dry
o Allow the amplifier to air for at least one hour
before turning the power back on
If you are unsure about the cleaning of the amplifier
and require more information, please ask your
dealer or contact Halcro at:
service@halcro.com
26