Troubleshooting - Halcro Eclipse mono Owner's Manual

Troubleshooting

The Halcro Eclipse mono amplifiers contain no user
serviceable parts. Please do not attempt to open the
unit as this will void the warranty and will expose you
to dangerous voltages.
Symptom
No sound or light
Red light is on, no sound
Blue light is on, no sound
Table 4
For all service requirements please contact your
dealer, or Halcro at
Remedy
Ensure mains cable is plugged in to the amplifier.
Ensure the mains cable is plugged into a working wall socket.
Ensure mains socket is turned ON.
Ensure the Master Switch is ON.
Check Fuse (p13, fig C, ⑦).
Press the Standby / ON switch to turn the amplifier on.
Ensure Input Selector Switch is set to the correct input.
Ensure Loudspeaker Cables are correctly connected (both ends).
Ensure the Input cables are correctly connected (both ends).
If using a preamplifier:
o
Check preamplifier is on and correctly connected
o
Check for a signal from the preamplifier (with headphones if possible)
Check audio source is on and correctly connected.
Check for a signal from the audio source (with headphones if possible).
Try a different audio source.
service@halcro.com
27