Control Mode - MedeaWiz Sprite 4K DV-S4 User Manual

MedeaWiz® Sprite® 4K
.

Control Mode

Select the external Control Mode for your application.
Serial Control is to use a Hydra® input expander or external show control device or micro
controller like a PIC, Atmel, Arduino, Raspberry Pi, or etc. using serial communications.
To use a pushbutton, motion sensor, or other trigger input to play files, select from below:
Trigger Low No Interrupt: A triggered file will play to the end with no interruption.
Trigger Low with Interrupt: A triggered file will play and can be interrupted by a new trigger.
Trigger Low Delayed: Triggered file will begin play at the end of file 000, with no interruption.
Trigger High No Interrupt: A triggered file will play to the end with no interruption.
Trigger High with Interrupt: A triggered file will play and can be interrupted by a new trigger.
Trigger High Delayed: Triggered file will begin play at the end of file 000, with no interruption.
If using Video Control Mode or Audio Control Mode
You must have at least 2 files. The loop file named 000 and a trigger file named 001.
The loop file 000 will play continuously until a trigger is received, then the trigger file will play.
After the trigger file finishes, the loop file will play again until a new trigger occurs. If using
multiple trigger files, name them in order 001, 002, 003 and etc. Each new trigger event will
play the next trigger file in order. After the last trigger file, the sequence will start again at file
001 on the next trigger event.
12 | P a g e