Table of Contents
Advertisement
.
Should I use an SD card or USB drive to hold the video files?
While files will play from the USB port from a USB drive, some UHD video may not play well
from some USB drives. For high bit rate files we recommend using the SD port with an SD card
of sufficient speed to match your video file's bit rate. For some HD video files a Class 4 may be
ok, while UHD 4K files may need a faster Class 10 at minimum. Test your video.
I accidentally changed the language and now I can't read the Setup Menu
You can reset the Sprite® to factory defaults to display in the English language without viewing
the monitor by these steps:
1) Remove the power plug for 10 seconds and then restore power
2) Wait 10 seconds or longer for start-up to finish
3) Press the Setup key on the remote control
4) Press the down arrow key 9 times
5) Press the Enter key 2 times
Do I have to name the files with those numbers or can I use names?
A) For Play Mode = Video Control Mode or Audio Control Mode (any Trigger or Serial Control use):
The Sprite® searches for the 000 to use as the looping file, and searches for 001 to use as the trigger.
However, you can name them this way:
000.myfilename.xxx
Do not use spaces, underscores or other special characters. Use 32 or less characters including the 2
periods. We explain the operation in this manual using only numbers to keep it simple.
We suggest you use the numbers 000, 001, etc. to test your files as a starting point, and then add the
longer names if you want them.
B) For Play Mode = Video Repeat All, Audio Repeat All, Photo Repeat All (Not Trigger or Serial Control)
File play order will follow ASCII code sort order
Order of precedence:
Space
Numbers
Capitols
Underscore
Lower case
or
001.someverylongnamefile.xxx
MedeaWiz® Sprite® 4K
38 |
P a g e
Advertisement
Table of Contents
