Table of Contents
Advertisement
MedeaWiz® Sprite®
.
Control Mode
Select the external Control Mode for your application
Select Serial Control to use an 8X78 input expander or external show control device or micro
controller like a PIC, Atmel, Arduino, Raspberry Pi, or etc. using serial communications.
Select Trigger Low No Interrupt to use a pushbutton or other contact closure event. When
triggered, the file named 001 will play to the end with no interruption.
Select Trigger Low with Interrupt to use a pushbutton or other contact closure. When
triggered, the file named 001 will play and will re-start if re-triggered.
Select Trigger High No Interrupt to use a contact opening event. When triggered, the file
named 001 will play to the end with no interruption.
Select Trigger High with Interrupt to use a contact opening event. When triggered, the file
named 001 will play and will re-start if re-triggered.
If using Video Control Mode or Audio Control Mode
You must have at least 2 files. The loop file named 000 and a trigger file named 001
The loop file 000 will play continuously until a trigger is received, then the trigger file will play.
After the trigger file finishes, the loop file will play again until a new trigger occurs.
11 |
P a g e
Advertisement
Table of Contents
