Table of Contents
Advertisement
MedeaWiz® Sprite® 4K
.
0xFC Select Loop Command can make any valid file on the SD or USB the looping file.
Valid file numbers are 0x00 up to 0xC8 (files named 000 up to 200)
Send 2 bytes, 0xFC, 0xXX where XX is the new file number to loop. This file will be the looping
file until a new 0xFC command is received or a power cycle. After a power cycle, the default file
0x00 (the file named 000) will be the looping file.
It can also be combined with an address as 3 bytes when the Sprite® 4K is set to an Address.
For example 0xE3, 0xFC, 0x05 will instruct any Sprite® 4K with address set to E3 to loop the file
named 005. Or you could use the Broadcast address 0xE0 to cause any Sprite set to any address
to follow the command.
33 |
P a g e
Advertisement
Table of Contents
