Table of Contents
Advertisement
5. Appendix
5.1 General Safety Guidelines
Note:
Only personnel familiar with local telco practices should install, replace, or service this
equipment.
Note:
Before starting equipment installation procedures, the user should read the whole chapter for
important information and safety warnings.
Before cabling the equipment, the user should be aware of standard safety practices and
the hazards involved in working with electricity to avoid accidents. See the following sec-
tion for all cautions and warnings to ensure that the installation is safe and free of haz-
ards.
Follow these guidelines to insure overall safety:
•
The user should keep all work areas clear and clean during and after installation.
•
The user should keep all tools away from walk areas where personnel could trip over them.
•
The user should not wear loose clothing that could catch on equipment.
•
The user should wear safety glasses if working under conditions that might be hazardous to eyes.
•
The user should not perform any action that creates an unsafe or hazardous situation for themselves or other
personnel.
Safety Precautions While Working with Electricity and electrically powered equipment:
•
Locate the Power Off switch for the system being installed or serviced. In the event of an electrical accident,
the user can quickly turn the power off.
•
Disconnect all power by turning the circuit breakers off before:
•
Installing or removing a chassis
•
Working near the power supply
•
Do not work alone if potential hazards exist.
•
Never assume that power is disconnected from a circuit; always check the circuit.
•
Inspect the work area carefully for possible hazards, such as moist floors, moist or wet ground, ungrounded
power extension cables, frayed power cords, and missing safety grounds.
Telesyn Wiring Solutions (Appendix)
5-1
Advertisement
Table of Contents
