At-Tn-K022-A - Allied Telesis ADSL8S Wiring Manual

AT-TN-K022-A

3.4 AT-TN-K022-A
3.4.0.1 ADSL16 High Performance - Optimized
The following diagram illustrates the wiring required at the distribution frame for the AT-TN-K022-A and
ADSL16 card. For each ADSL16 card, the user would:
Connect one AT-TN-K019-A of correct length from the ADSL16 card to the distribution frame.
1.
Connect one AT-TN-K022-A of correct length from the splitter card ADSL connector to the distribution
2.
frame.
Using CAT5 wiring, jumper the AT-TN-K019-A pairs in step 1 above to the AT-TN-K022-A pairs in step 2
3.
above.
Connect one AT-TN-K022-A of correct length from the splitter card LINE connector to the distribution
4.
frame.
Connect a customer-supplied CAT3 cable/wiring of correct length from the splitter card PHONE connector
5.
to the Class #5 switch for POTS service.
To connect the first subscriber, the user would:
Connect the subscriber's incoming line to the AT-TN-K022-A installed in step 4 above. The subscriber's
1.
pair would be connected to pair 1 on the AT-TN-K022-A.
(Note that subsequent subscriber's pairs would be connected to pair 2, pair 3, and so on.)
Connect the subscriber's corresponding pair to the Class #5 switch for POTS service.
2.
3-4
Telesyn Wiring Solutions (Installation recommendations)