System Status - Electro-Voice EVERSE Series User Manual

EVERSE Battery-powered Loudspeaker
7.
8.
9.
10. MAINS IN – AC connection is established via an IEC-connector.
11. POWER - Switch for power ON or OFF of the loudspeaker. The LCD screen lights up
12. DC POWER OUT - DC power output jack for use with the 5.5 mm outer diameter and
Warning!
The DC power jack is a power output. THIS IS NOT A CHARGING PORT. DO NOT connect a
!
DC power adapter or attempt to re-charge the EVERSE loudspeaker's battery with this
connector. Doing so may cause damage to the loudspeaker and void of warranty.
5.2

System status

Normal
1.
2.
3.
4.
5.
6.
7.
8.
9.
Electro-Voice
MIX OUT - XLR output sends either the mix of all input signals or the stereo L or stereo
R signal to another loudspeaker or subwoofer.
FOOTSWITCH - ¼-inch TRS connector for connecting footswitch control to toggle FX
on/off.
Mobile device charging port - 5 V 1.5 A charging for mobile devices.
when the power is turned ON, after approximately three seconds.
2.5 mm inner diameter DC power cable included with the EVERSE-TRAY accessory. The
DC POWER OUT jack is capable of powering a wireless microphone receiver which uses
a center pin positive polarity and draws 500mA or less at 12 Volts DC, such as the
Electro-Voice RE3 or R300 wireless microphone receiver.
VOL - Indicates the master gain of the system in dB. The range is from -80 dB to
+10 dB, in 1 dB increments.
INPUT 1 - VU meter displays the signal level of INPUT 1 into the amplifier INPUT 1
connector. The display of P indicates 48V phantom power is switched on.
INPUT 2 - VU meter displays the signal level of INPUT 2 into the amplifier INPUT 2
connector. The display of H indicates Hi-Z instrument connection is present on the
INPUT 2 TRS connector.
INPUT 3/4 - VU meter displays the signal level of INPUT 3/4 into the amplifier from
either Bluetooth® streaming or 3.5 mm mini jack connection.
MAIN - VU meter displays the signal level of the MAIN output.
DUCK - Ducking is activated on either or both INPUT 1 and INPUT 2.
AFS - Automatic feedback suppression is enabled.
BATTERY status - Indicates the battery level of the loudspeaker and if the battery is
charging (when MAINS is connected).
FUNCTION indicator - Indicates whether the system is in MIXER or BASIC mode.
User manual
Amplifier DSP | en 27
2023-12 | 02 |