System Status - Electro-Voice EVERSE 8 User Manual

EVERSE 8
7.
8.
9.
10. MAINS IN – AC connection is established via an IEC-connector.
11. POWER - Switch for power ON or OFF of the loudspeaker. The LCD screen lights up
12. DC POWER JACK - 5.6 mm DC power out, 12 V DC 500 mA for powering wireless
Warning!
The DC power jack is a power output. THIS IS NOT A CHARGING PORT. DO NOT connect a
!
DC power adapter or attempt to re-charge the EVERSE loudspeaker's battery with this
connector. Doing so may cause damage to the loudspeaker and void of warranty.
5.2

System status

Normal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Status display - Alternately shows the following:
Electro-Voice
MIX OUT - XLR output sends either the mix of all input signals or the stereo L or stereo R
signal to another loudspeaker or subwoofer.
FOOTSWITCH - ¼-inch TRS connector for connecting footswitch control to toggle FX on/
off.
Mobile device charging port - 5 V 1.5 A charging for mobile devices.
when the power is turned ON, after approximately three seconds.
microphone receivers, such Electro-Voice RE3 or R300 wireless microphone receivers.
VOL - Indicates the master gain of the system in dB. The range is from -80 dB to +10 dB,
in 1 dB increments.
INPUT 1 - VU meter displays the signal level of INPUT 1 into the amplifier INPUT 1
connector. The display of P indicates 48 V phantom power is switched on.
INPUT 2 - VU meter displays the signal level of INPUT 2 into the amplifier INPUT 2
connector. The display of H indicates Hi-Z instrument connection is present on the
INPUT 2 TRS connector.
INPUT 3/4 - VU meter displays the signal level of INPUT 3/4 into the amplifier from either
Bluetooth® streaming or 3.5 mm mini jack connection.
MAIN - VU meter displays the signal level of the MAIN output.
DUCK - Ducking is activated on either or both INPUT 1 and INPUT 2.
AFS - Automatic feedback suppression is enabled.
BATTERY status - Indicates the battery level of the loudspeaker and if the battery is
charging (when MAINS is connected).
FUNCTION indicator - Indicates whether the system is in MIXER or BASIC mode.
1 - Indicates the selected preset number. There are five user-defined presets available.
E - Edited. Indicates the preset is not saved. When the preset is saved, the E is not
User manual
Amplifier DSP | en 33
2022-10 | 02 | F.01U.401.530