Advertisement
Specifications
Setup - Before use:
read the entire iMpOrtant Safety infOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 18.
Mounting
Mount Saw to a stable, level surface
or saw stand capable of supporting the
weight of the saw and workpiece.
WarninG! tO preVent SeriOuS inJury:
Verify that installation surface has no hidden
utility lines before drilling or driving hardware.
assembly
1. Insert the ends of the Extension Supports into the
holes in the sides of the Base. Use Support Bolts to
level and secure Extensions.
The upper edge of the Extensions will be level
with the surface of the saw. This provides a
wider base for the work material to rest on.
Page 8
Electrical Rating
Rated No Load Speed
Cutting Capacity at 0°
Cutting Capacity at 45°
Maximum Bevel
Maximum Miter
Saw Blade
Workpiece
extension Support
Support Bolt
For technical questions, please call 1-888-866-5797.
120VAC / 60Hz / 15A
n
: 5000/min
0
2-3/4" x 12"
1-9/16" x 12" (Bevel)
1-9/16" x 8-1/4" (Miter)
45° Left
45° (Left and Right)
10" Diameter (Ø254mm)
5/8" Round Arbor
5000 Minimum RPM Rating
1. Place Saw on mounting surface. Using
the base as a template, mark locations
of four mounting holes on surface.
2. Use appropriate hardware (sold separately). Drill
pilot holes into marked locations, then place Saw
over holes and secure Saw to mounting surface.
2. Thread the Miter Lock Handle into the end
of the Table until securely in place.
3. Slip Dust Bag over Dust Port at the
rear of the Saw Head Assembly.
Item 61971
Advertisement
