FeatuReS .........9 woRk piece and woRk aRea Set up ..........10 handle Rotation ......10 tRiggeR FeatuReS ...... 10 geneRal cutting ......10 plunge cutting ......11 metal cutting ......11 SKU 65298 For technical questions, please call 1-800-444-3353. Page 2...
SKU 65298 For technical questions, please call 1-800-444-3353. Page 3...
Page 4
Eye protection injury. must be ANSI-approved and breath- ing protection must be NIOSH-ap- use personal protective equip- ment. always wear eye protection. SKU 65298 For technical questions, please call 1-800-444-3353. Page 4...
Properly maintained cutting tools with sharp cutting edges are Avoid unintentional starting. Prepare to begin work before turning on the less likely to bind and are easier to control. tool. SKU 65298 For technical questions, please call 1-800-444-3353. Page 5...
Page 6
• Arsenic and chromium from chemi- not being caused or worsened from cally treated lumber SKU 65298 For technical questions, please call 1-800-444-3353. Page 6...
They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Labora- tories, Inc., the Canadian Standard Association, and the National Electri- SKU 65298 For technical questions, please call 1-800-444-3353. Page 7...
No Load Revolutions per Minute outdoors, make sure it is marked with n 0 xxxx/min. (RPM) the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use. SKU 65298 For technical questions, please call 1-800-444-3353. Page 8...
For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. SKU 65298 For technical questions, please call 1-800-444-3353. Page 9...
Trigger, then space under and behind the work- press the Trigger Lock Button. To piece for the Saw Blade. Ensure you unlock the Trigger lock mechanism, SKU 65298 For technical questions, please call 1-800-444-3353. Page 10...
Trigger to stop the tool. If the continuous run Trigger Lock was ting oil to avoid heat build-up. Follow used, squeeze and release the Trig- the “General Cutting” section in this manual. SKU 65298 For technical questions, please call 1-800-444-3353. Page 11...
The carbon brushes may require maintenance when the motor perfor- mance of the tool decreases or stops working completely. To maintain the brushes: SKU 65298 For technical questions, please call 1-800-444-3353. Page 12...
RISk AND LIABILITy ARISINg OUT OF HIS OR HER REPAIRS TO THE ORIgINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISINg OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 65298 For technical questions, please call 1-800-444-3353. Page 13...
If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not avail- able individually as replacement parts. SKU 65298 For technical questions, please call 1-800-444-3353. Page 14...
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 SKU 65298 For technical questions, please call 1-800-444-3353. Page 16...