Table of Contents
Advertisement
4. All digits will light up, checking the display functions. The checking
procedure will be completed after about 3 seconds .
..
5. After all symbols disappear, the display will show "00". The monitor is
"Ready to Measure" and will automatically inflate the cuff to begin
measurement.
6. When the measurement is
completed,
the cuff will deflate entirely
and systolic pressure, diastolic pressure and pulse will be shown
simultaneously on the LCD
screen.
The measurement is then
automatically stored into memory.
NOTE:
• This monitor automatically turns off approximately 1 minute after last
operation.
You may also press the
START/STOP button
to turn the unit off.
• To interrupt the measurement, you may press the
START/STOP
button.
The cuff will deflate immediately after this button is
pressed.
• If the cuff does not stop inflating, remove the cuff at once.
Advertisement
Table of Contents
