Car Jack Protection - CrimeStopper CS-2002DC Series II Installation And Operating Instructions Manual

CARJACK PROTECTION
PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming options
(13) & (14). See page 9. We recommend this mode should only be used in serious situations. When the Ignition is on
(vehicle is running), and a door is opened, the Carjack countdown sequence will be initiated. 90 Seconds later, the
unit will begin a Carjack Cycle consisting of 15 seconds of pre-warning chirps turning into a full system activation with
siren/flashing light pulses for up to 5 min. To reset Passive Carjack, IGNITION MUST BE ON AND DOORS MUST BE
CLOSED, then press the override/program button (3) times.
FULL-TIME CARJACK
Use in case of extreme Carjack threat only. This feature provides full-time Carjack protection and must be enabled
before use through Alarm programming options (13) & (14). See page 9. EVERY TIME the Ignition is turned ON or a
door is opened, then closed with the Ignition ON, a Carjack countdown sequence will be initiated. 90 Seconds later,
the unit will begin a Carjack Cycle consisting of 15 seconds of pre-warning chirps turning into a full system activation
with siren/flashing light pulses for up to 5 min. You must reset the unit every time the IGNITION is turned on or a door
is opened and closed when the ignition is on. To reset IGNITION MUST BE ON AND DOORS MUST BE CLOSED,
then press override/program button (3) times.
NOTE: When FULL TIME CARJACK is in effect, it must be reset every time the key is turned on, Door is
opened, before entering VALET mode, and before Programming options or transmitters. It is always in effect
each time the Ignition is turned on and/or a door is opened with Ignition on.