Optex REDSCAN mini-Pro Series Installation Instructions Manual page 54

INSTALLATION INSTRUCTIONS
Parts layout inside the cover and their functions
Reset button
If you forget your IP address or password,
you can initialize it by following the steps below.
Rest button
1. Turn Off the Power supply. Remove the terminal cover.
2. Power on, then press and hold the reset button.
3. All LEDs blinking after 70 seconds.
Then, in this status, release the reset button.
4. REDSCAN mini-Pro reboot itself.
Attach the terminal cover and reconnect REDSCAN mini-Pro.
Please note that IP address has initialized to the default
Default IP: 192.168.0.126
EN-54
REDSCAN mini-Pro