Advertisement
Installation
!
Due to excessive mishandling, this device could be damaged during
transportation. To avoid the high cost of troubleshooting and repairs due to
repeated mounting and removal, we recommend that you assemble all
components first after delivery and test the device with the on-board charger
power supply. Make sure that the device is visibly undamaged prior to installation.
Contact our Customer Care with any questions or concerns.
I. Install the Device
1.
Turn off the engine of the car.
2.
Place the MicroSD card into the slot.
3.
Secure the dashcam to the rearview mirror of the car.
4.
Plug the GPS module into the GPS port and secure the module to a pillar on the
inside of your vehicle that is near the reveiw mirror. The antenna receiver side (the
side without 3M adhesive) faces the outside and the side with 3M adhesive faces
down. It should be properly secured.
5.
Plug the charger into the car's cigarette lighter and connect it to the dash cam's
Type-C Port.
Note:
The optional rearview camera is mounted on the rear of the car. Pay attention to its
orientation during installation. Plug the rearview camera connector into the
corresponding port of the dashcam once the installation is completed. Adjust the
position of the lens to ensure that it aligns horizontal with the ground. Start the
engine to check the video functionality of the device.
8
Advertisement
Need help?
Do you have a question about the M2 Max and is the answer not in the manual?
Questions and answers
What is the correct daylight savings time zone for the west on the Rexing M2 Max camera?
The Rexing M2 Max camera allows users to enable or disable Daylight Savings Time (DST) in its settings. Users can select their appropriate time zone and adjust the DST option accordingly.
This answer is automatically generated