Extreme Networks NetSight NS-A-20 Installation Manual page 18

=================================================================
The system clock can be set to use UTC. Specifying no for using UTC,
sets the hardware clock using localtime.
=================================================================
Do you want to use UTC (y/n) [n]?
13 In the Set Time Zone screen, select the appropriate time zone and press [Enter].
=================================================================
Set Time Zone
=================================================================
You will now be asked to enter the time zone information for this
system. Available time zones are stored in files in the /usr/share/
zoneinfo directory. Please select from one of the following example
time zones:
1. US Eastern
2. US Central
3. US Mountain
4. US Pacific
5. Other - Shows a graphical list
=================================================================
Enter selection [1]:
14 The Modify Settings screen summarizes the settings you have entered and provides an opportunity
to modify the settings, if desired. Enter 0 to accept the settings.
================================================================
Modify Settings
=================================================================
All of the information needed to complete the installation of the
NetSight Appliance has been entered. Enter 0 or any key other than a
valid selection to continue. If you need to make a change, enter the
appropriate number from the choices listed below.
=================================================================
0. Accept settings and continue
1. Set the root user password
2. Set user to run server as
3. Set hostname and network settings
4. Set SNMP settings
5. Set the system time
6. Modify all settings
Enter selection [0]:
The NetSight appliance software is automatically installed. This could take a few minutes. When the
installation is complete, you'll see the following screen.
=================================================================
Extreme Networks - NetSight Suite Appliance - Setup Complete
=================================================================
Setup of the NetSight Appliance is now complete. The appliance is now
operational and ready to accept remote connections. Details of the
installation are located in the /var/log/install directory.
NetSight NS-A-20 Installation Guide
Configuration
18