Extreme Networks NetSight NS-A-20 Installation Manual page 16

6 In the NetSight Suite Appliance Network Configuration screen, enter the requested configuration
information and press [Enter].
If you plan to use DNS, enter the IP address of the name server. If you are using a name server, you
must enter a domain name for the appliance. If you are using an NIS server to authenticate users
logging into the appliance, make sure the NIS domain name is valid or users may not be able to log
in to the NetSight applications.
=================================================================
NetSight Suite Appliance Network Configuration
=================================================================
Enter the hostname for the appliance (Required):
Enter the IP address for <hostname> [192.168.1.10]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [192.168.1.1]:
Enter the IP address of the name server (Optional):
Enter the domain name for <hostname> (Optional):
Do you want to use NIS (y/n) [n]? y
Enter the IP address of the NIS server:
Enter the NIS domain name (Required):
7 In the Confirm Network Settings screen, you can accept the current configuration or modify the
settings.
=================================================================
Confirm Network Settings
=================================================================
These are the settings you have entered. Enter 0 or any key other
than a valid selection to continue.If you need to make a change,
enter the appropriate number now or run the /usr/postinstall/
dnetconfig script at a later time.
=================================================================
0. Accept settings and continue
1. Hostname:
2. IP address:
3. Netmask:
4. Gateway:
5. Nameserver:
6. Domain name: <domain name>
7. NIS Server/Domain:
Enter selection [0]:
8 In the SNMP Configuration screen, enter the requested information for each line and press [Enter].
=================================================================
SNMP Configuration
=================================================================
The following information will be used to configure SNMP management
of this device. The SNMP information entered here must be used to
contact this device with remote management applications such as
NetSight Console.
=================================================================
Please enter the SNMP user name [snmpuser]:
Please enter the SNMP authentication credential [snmpauthcred]:
Please enter the SNMP privacy credential [snmpprivcred]:
NetSight NS-A-20 Installation Guide
<hostname>
192.168.1.10
255.255.255.0
192.168.1.1
Configuration
16