Quectel FCM561D-P Hardware Design page 64

Wi-Fi&Bluetooth Module Series
including the transmitter operation. The host manufacturer has to be aware not to provide
information to the end user regarding how to install or remove this RF module in the user's manual
of the end product which integrates this module The end user manual shall include all required
regulatory information/warning as show in this manual.
2.4 Limited module procedures
Not applicable The module is a Single module and complies with the requirement of FCC Part 15
212.
2.5 Trace antenna designs
Not applicable The module has its own antenna, and doesn't need a hosts printed board micro strip
trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between
the antenna and users" body; and if RF exposure statement or module layout is changed, then the
host product manufacturer required to take responsibility of the module through a change in FCC ID
or new application The FCC ID of the module cannot be used on the final product In these
circumstances, the host manufacturer will be responsible for reevaluating the end product (including
the transmitter) and obtaining a separate FCC authorization.
2.7 Antennas
Antenna Specification are as follows:
Type: PCB Antenna
Gain: 1 dBi Max
This device is intended only for host manufacturers under the following conditions: The transmitter
module may not be co-located with any other transmitter or antenna; The module shall be only used
with the internal antenna(s) that has been originally tested and certified with this module. The
antenna must be either permanently attached or employ a "unique" antenna coupler.
As long as the conditions above are met, further transmitter test will not be required However, the
host manufacturer is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, etc).
2.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating "Contains FCC ID:
XMR2023FCM561DP" with their finished product.
2.9 Information on test modes and additional testing requirements
Host manufacturer must perform test of radiated & conducted emission and spurious emission, e.t.c
according to the actual test modes for a stand-alone modular transmitter in a host, as well as for
multiple simultaneously transmitting modules or other transmitters in a host product. Only when all
the test results of test modes comply with FCC requirements, then the end product can be sold
legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
FCM561D-P_Hardware_Design 63 / 65