Before Operating, Check The Position Of; Checking Accessory Items - Pioneer SX-2900 Operating Instructions Manual

BEFORE OPERATING, CHECK THE POSITION OF THESE
SWITCHES
TWO VOLTAGE SELECTOR SWITCHES
Only multi-voltage models are provided with these switches. U.S.,
Canadian, European, U.K., and Australian models are not provided
with these switches.
Main voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model with 110 V setting in Saudi Arabia.
The line voltage selector switches are on the rear panel. Before your
model is shipped from the factory, these switches are set to the power
requirements of the destination. Check that they are set properly before
plugging the power cord into the AC outlet. If the voltage is not properly
set or if you move to an area where the voltage requirements differ,
adjust the selector switches as follows.
1. Use a medium-size screwdriver.
2. First, insert a screwdriver in the groove of the voltage selector at
the right, and adjust so that the tip of the groove points to the voltage
value of your area.
3. Next, insert a screwdriver in the groove of the voltage selector at
the left and adjust until the voltage is the same as at the right.
TWO VOLTAGE SELECTORS
MN0OV,120-127V 2 © & 220V:240V
220V 240V
MOV = 120-127V
CHECKING ACCESSORY ITEMS
CHANNEL STEP SWITCH
(Multi-voltage model only)
The unit has been factory preset to the channel allocation and de-
emphasis value for the area in which it is to be sold. If these values are
set incorrectly, the frequency display may stop at the wrong frequency,
or sound may be distorted, resulting in an inability to reproduce reception
signals at their proper sound quality. For this reason, be sure to confirm
that the values are set correctly before first using the unit.
[100 kHz/10 kHz] position:
Set to this position for areas with an FM reception step of 100 kHz,
AM 10 kHz.
[50 kHz/9 kHz] position:
Set to this position, for areas with an FM reception step of 50 kHz, AM
9 kHz.
NOTE:
When unsure about the channel allocation and de-emphasis values for
your area, consult your dealer for correct information.
CHANNEL STEP
50kHz=FM=-100kHz
9kHz—— AM—10kHz
| a |
Other countries North and South America
AM Loop Antenna FM Antenna
Setting Up the AM Antenna
e Insert the claw on the bottom of the antenna into the groove in
the leg.
¢ Place the antenna on a level surface and rotate it to locate the
orientation that yields the best reception.
e To permanently fix the antenna, screw the leg to a wall or
something similar before assembling (fixing the antenna in the
direction that gives the best reception).
Remote control unit
SY tC
Dry cell battery
(size ""AAA'' (RO3/UM-A4))
lead wire
lead wire
3
<ARB1286>