Parameter Control; Tone Controller; Graphic Equalizer - Pioneer VSX-D2S Operating Instructions Manual

PARAMETER CONTROL
[TONE CONTROLLER]
STANDARD}
e Enables boosting and attenuation of BASS and TREBLE for the
FRONT, CENTER, and REAR channels. (CENTER and REAR are not
selectable in STEREO (2 ch.) Rear is not selectable when selecting
3 ch LOGIC with the PRO LOGIC PROCESSOR.)
}): Boosts.
Ee : Attenuates.
FLAT:
Sets all the image operation knobs to the center position for flat
frequency response.
STANDARD:
Returns you to the standard settings (only operates when the
system is set to MOVIE).
[GRAPHIC EQUALIZER]
eEnables adjustment of equalization for the front and center
channels at 7 frequency points.
1. Move the cursor to "FRONT", "CENTER", "FLAT", or
"STANDARD", and press the ENTER button.
@ Move the cursor to "FRONT" or "CENTER", press the ENTER
button, and the cursor moves to the graphic equalizer imnage's
control sections sliders. ("CENTER'" is not selectable inS TEREO
{2 ch.).)
© Move the cursor to "FLAT", press the ENTER button, and all the
sliders on the graphic equalizer image are set to the center
position for flat frequency response.
® Moving the cursor to "STANDARD" and pressing the ENTER
button takes you to the standard settings. (Only operate s when
the system is CONCERT.)
2. With the <) and > buttons, move the cursor to the freqquency
you want to adjust, and then attenuate or boost with the A
and V buttons.
® To adjust each of the frequencies, repeat procedure ?.
3. When you have finished adjusting, press the ENTER button.
© This returns you to the selection mode mentioned in1.
57
<A 1455>