Selecting System Selec Cisciclunitieniunnernateditiae; Operating Tuner; Manual/Auto Tuning Into Stations - Pioneer VSX-D2S Operating Instructions Manual

SELECTING SYSTEM
Besides basic functions, this unit features ten built-in add-on
component functions. You can select a maximum of four of these
functions to create your own original system, and register four of
your system combinations (A to D) for recall later with a SYSTEM
SELECTOR button.
Using the GUI (Graphic User Interface) function enables system
design with on-screen display (TV). (See pages 54 and 55).
As well as the four systems you can create yourself, there are four
factory preset systems you can cal! up in sequence with the
SELECTION button.
[Preset systems]
STEREO : AMPLIFIER + GRAPHIC EQUALIZER + EXPANDER/
COMPRESSOR
MOVIE : AMPLIFIER + PRO LOGIC PROCESSOR + BASIC
SFC (MOVIE) + TONE CONTROLLER + BASS
ENHANCER ;
: AMPLIFIER + BASIC SFC (CONCERT) + GRAPHIC
EQUALIZER + BASS ENHANCER
SPORTS : AMPLIFIER + BASIC SFC (SPORTS) + PARAMETRIC
EQUALIZER + EXPANDER/COMPRESSOR + BASS
ENHANCER
CONCERT
OPERATING TUNER
NOTE:
© When no systems are registered, pressing a SYSTEM SELECTOR
has no effect. (The system is AMPLIFIER only.)
© Switch parameters (sound quality etc.) using GUI (Graphic User
Interface). You can memorize the parameter settings for each of the
8 SYSTEMS.
© The volume setting (volume knob position] is memorized for each
of the eight systems, so when a system is selected, the volume
returns to the previous level setting.
SYSTEM SELECTOR buttons/indicators
SELECTION button
Press the POWER switch to the ON position.
Select TUNER with the input selector.
Be sure to turn the TAPE 2 MONITOR button OFF when listening to
FM or AM broadcasts.
*Broadcast reception is not possible unless an antenna is
connected, so be sure to connect one.
MANUAL/AUTO TUNING INTO STATIONS
1. Use the FM/AM button to select either FM or AM.
2. Press TUNING + button for higher frequencies or TUNING —
button for lower frequencies.
The TUNED indicator lights up when a station of sufficient signal
strength is tuned in.
© One Step Tuning:
Press + or — button and release quickly. The frequency will change
by one step each time the button is pressed. Press as many times as
necessary to tune in the desired station.
¢ Auto Tuning:
Press + or — button until the frequency starts to change {about 1
sec.), then release it. The tuner automatically searches for a
broadcasting station and stops when one is found, and the TUNED
indicator fights up.
To search for another station, press again.
NOTE:
When the signal level is too weak for reception, the unit cannot
perform Auto tuning. In this case, change to Manual tuning.
High Speed Manual Tuning:
Keep + or — button pressed. The frequency changes continuously,
and stops when the button is released.
30
<ARB1455>
Last station memory
When the POWER switch is pressed to turn power on, the last station
received before the power was turned off will be tuned in again.
When the power is ON, if the FM/AM button is pressed, the last
station received on that band will be tuned in again.
STATION CALL
FM/AM button buttons
ee ee ee
Sse:(
sees]
ooooc
@©O-> Jelssceo
el
E ==
TUNING +, — buttons