Table of Contents
Advertisement
DoorScan
Display and Control Elements
Display and Control Elements
Interface
1
Blank LED (green)
Illuminated
Not illuminated
2
DIP LED (green)
Illuminated *
Not illuminated
Flashing slowly (1 Hz)
3
Teach LED (yellow)
Illuminated
Flashing slowly (1 Hz)
Flashing quickly (2 Hz)
Flickering (8 Hz)
Not illuminated
4
Status LED (red)
Illuminated
Flashing
Not illuminated
5
DIP switches
6
Teach button
7
NPN/PNP plug-in jumper
6
1
2
4
5
3
7
6
Status
Blanking active
Blanking not active or only partially active
Status
DIP position ON
DIP position OFF
Setting changed
Status
Teach mode ready
Teach-in surface
Teach-in blanking (door opening and closing motion)
Teach-in required
Sensor ready for operation
Status
Detection or standby mode active
Fault indication
No detection
Status
See „Set DIP switch rows 1 and 2" on page 16
Status
See „Teach-in process" on page 14
See „Select Output Configuration" on page 15
* LEDs switch off after some time
Advertisement
Table of Contents
