Danfoss 088U0200 Manual page 16

Instruction CF-MC Master Controller
6. Con guration
6.1 Actuator Outputs
Activate Output mode on Master Controller ( g. 23)
• Use the menu selection button
LED ashes
• Activate Output mode by pressing OK
Select the output con guration
• Press the output selection button
ble output con gurations
below:
• 1 LED: The outputs are con gured to NC actuators with ON/OFF regu-
lation (default)
• 2 LEDs: The outputs are con gured to NO actuators with ON/OFF
regulation
• 3 LEDs: The outputs are con gured to NC actuators with Pulse Width
Modulation (PWM) regulation for oor heating
• 4 LEDs: The outputs are con gured to NO actuators with Pulse Width
Modulation (PWM) regulation for oor heating
• 5 LEDs: A Remote Controller is installed, and it is not possible to
change settings from the Master Controller
• Activate selected output con guration by pressing OK
Note: During periods with no output activations the Master Controller will
run a valve motion program every 2 weeks and it will last for up to 12
minutes. Individual output con guration is possible with Remote Con-
troller, CF-RC, see separate instruction.
16
VI.UH.K1.52
to select the Output mode. Output
and toggle between the possi-
- the output LEDs will be ON – indicated
Produced by Danfoss Floor Heating Hydronics 08.2005
. Output LED goes ON