Advertisement
Quick Links
Operating Guide
NovoCon® S CO6, Energy, I/O - High Accuracy Actuator
*VIHUI302*
IP54
❶
IP40
❺
①
❼
Common ground shall be
used for all devices on the
same network.
NovoCon® digital cable
Actuator NovoCon®
ChangeOver
NovoCon® Energy cable
- PT1000 surface sensors
NovoCon® Energy cable
- PT1000 immersed sensors
© Danfoss | 2017.05
❷
②
Red
Power
Common ground for power
Black
and bus signal wire
Green
´+´ non-inverting signal wire
White/green
´−´ inverting signal wire
Actuator NovoCon®
ChangeOver
6
Purple O-ring
❸
❻
①
②
③
Digital port
Port for CO6 actuator or Energy cable, I/O cable,
analog cable or voltage booster.
Digital port
NovoCon® analog cable
Actuator NovoCon® ChangeOver
Energy
6
Blue O-ring
NovoCon® I/O cable
Red
Black
Blue
Grey
White
Yellow
Orange
❹
Calibration:
Press button ① until two
LED's are turned on
DIP switch: ②
Manual override:
Adjust wheel ③
Red
Power 24V
Black
GND
Grey
Analog input
Blue
Analog input ground
Flexible
6
Red
Power 24V
Black
GND
White
CO6 Control signal
Grey
CO6 Feedback signal
Power 24V
Power ground. T1, T2 and V output signal ground.
V/mA input signal ground
V/mA input signal
V output signal
T1 or resistance input
T2 or resistance input
VI.HU.I3.02 | 1
Advertisement
Related Manuals for Danfoss NovoCon Series
Summary of Contents for Danfoss NovoCon Series
- Page 1 Power ground. T1, T2 and V output signal ground. Blue V/mA input signal ground Grey V/mA input signal White V output signal NovoCon® Energy cable Yellow T1 or resistance input - PT1000 immersed sensors Orange T2 or resistance input VI.HU.I3.02 | 1 © Danfoss | 2017.05...
- Page 2 Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary eady agreed.