Danfoss 088U0200 Manual page 20

Instruction CF-MC Master Controller
6.5 Reset of Master Controller
Resetting the Master Controller to factory settings ( g. 23)
• Disconnect the 230V power supply to the Master Controller until the
power LED
• Press and hold at the same time the menu selection button
button
power supply to the Master Controller and release the three buttons
when the power LED
• All the output LEDs
all output LEDs go OFF.
20
VI.UH.K1.52
is OFF
, and the output selection button
is ON
will be ON. The Master Controller is reset when
Produced by Danfoss Floor Heating Hydronics 08.2005
. Reconnect the 230V
, the OK