Traveling On Slope - Case CX14 Operator's Manual

I . SWINGING FUNCTION
Make certain the swing area of machine is clear
of all persons and obstacles before operating
swing controls. Sound horn before swinging
machine. If necessary, have a flagman signal
operator during operation to help prevent injury
to persons or damage to obstacles and
equipment.
J. TRAVELING ON SLOPE
Use extreme caution when traveling on slopes,
machine could turnover or slide causing injury
or machine damage.
Keep the bucket at the height 30 ~ 40 cm (12 ~
16 inch) above the ground level, and wear the
safety belt at all times.
Never make a change of direction on the slope
or cross over the slope.
K. FROZEN & SNOW COVERED WORK SITES
Use extreme caution when operating the
machine on frozen or snow covered work sites.
Operate all controls slowly and cautiously to
prevent sudden movements such as start/stop/
turn, that may cause the machine to
unexpectedly shift, slide or move. Even on the
slightest slope, when snow is present or work
area is frozen, it can allow a machine to
unexpectedly move. Snow on shoulders or snow
drifts can be much deeper than expected. The
machine can easily become buried under such
conditions. Use extreme caution while operating
the machine around or in snow.
Be careful for frozen ground that becomes soft
along with the increase of ambient temperature.
L. TRAVEL
Position the attachment as shown in illustration
before beginning travel. On rough terrain move
the machine at slow speeds, and do not turn
suddenly. Avoid travelling over obstacles.
Should it become necessary to travel over an
obstacle, keep the attachment low to the ground
and travel at extremely slow speed.
SECTION 1 - SAFETY PRECAUTIONS
USE EXTREME CAUTION ON FROZEN
SURFACES OR SNOW
90˚~110˚
30cm~40cm
(12~16in)
PV1-30
PV1-31
PV1-32
PV1-33
1-13