Case CX14 Operator's Manual page 16

Q. KEEP CLEAN CAB FLOOR AND DRIVER'S
SEAT
Do not place any parts and tools in the driver's
cabin to prevent injury due to slippage and
stumbling. Remove any debris from the cab
floor, control levers, handrails, etc. Make sure
to keep all operating controls clean at all times
R. HOW TO HANDLE LIFE HAMMER-CAB only
A life hammer is provided on the right side of
cab. In case of emergency, take the life
hammer, break the cab glass, and escape from
the cab. In addition, the life hammer is equipped
with a cutter on the lever side to cut the seat
belt, etc.
S. PERFORM PRE-START INSPECTION
Walk around the machine before starting the
machine, perform a PRESTART inspection of
the machine and make note of any abnormality.
If any problems are found, repair or replace
defective components immediately. DO NOT
OPERATE THE MACHINE until all problem
areas are properly repaired. Always keep the
windshield, working lamps, and mirrors clean
for good visibility.
T. TAG OUT MACHINE DURING MAINTENANCE
Before performing any inspection or
maintenance procedures to the machine, fill
out and post to the operators controls a DO
NOT OPERATE tag to warn persons not to start
the machine. Order
LC20T01001P1. Make sure to inform the
supervisor and all operators that the machine
is under inspection or maintenance and they
will be informed when the machine is ready for
normal operation.
SECTION 1 - SAFETY PRECAUTIONS
tag Part No.
LIFE HAMMER
PV1-16
CUTTER
PV1-17
PV1-18
PV1-19
1-9