Mounting Instructions - M-system MECHATROLINK R7K4FML3-6-DAC32B Instruction Manual

■ I/O TERMINAL ASSIGNMENT
10 11 12 13 14
COM X1 X3 X5
1 2 3 4 5
COM X0 X2 X4 X6
NO. ID FUNCTION
1 COM Common
2 X0 Input 0
3 X2 Input 2
4 X4 Input 4
5 X6 Input 6
6 X8 Input 8
7 X10 Input 10
8 X12 Input 12
9 X14 Input 14

MOUNTING INSTRUCTIONS

■ DIN RAIL MOUNTING
• Mounting
1) Set the upper hook at the rear side of the unit on the DIN
rail.
2) Push in the lower.
1
• Dismounting
1) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
2) Pull the lower of the unit.
3) Remove the upper hook of the unit from the DIN rail.
3
15 16 17 18
X7 X9 X11 X13 X15
6 7 8 9
X8 X10 X12 X14
NO. ID FUNCTION
10 COM Common
11 X1 Input 1
12 X3 Input 3
13 X5 Input 5
14 X7 Input 7
15 X9 Input 9
16 X11 Input 11
17 X13 Input 13
18 X15 Input 15
2
2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
28 29 30 31
V+ Y1 Y3 Y5
19 20 21 22 23
V- Y0 Y2 Y4
NO. ID FUNCTION
19 V– Out. Common
20 Y0 Output 0
21 Y2 Output 2
22 Y4 Output 4
23 Y6 Output 6
24 Y8 Output 8
25 Y10 Output 10
26 Y12 Output 12
27 Y14 Output 14
■ SURFACE MOUNTING
1) Insert the two DIN rail mounter sliders until it clicks
once, as shown below.
1
2) Mount the unit with M4 screws referring the Mounting
Requirements. (Torque: 1.4 N·m)
R7K4FML3-6-DAC32B
32 33 34 35 36
Y7 Y9 Y11 Y13 Y15
24 25 26 27
Y6 Y8 Y10 Y12 Y14
NO. ID FUNCTION
28 V+ External excitation
29 Y1 Output 1
30 Y3 Output 3
31 Y5 Output 5
32 Y7 Output 7
33 Y9 Output 9
34 Y11 Output 11
35 Y13 Output 13
36 Y15 Output 15
1
EM-7773-E Rev.3 P. 3 / 11