Mounting Instructions - M-system R7G4HH-A-YVF4 Instruction Manual

MOUNTING INSTRUCTIONS

■ DIN RAIL MOUNTING (PARALLEL)
• Mounting
1) Set the upper hook at the rear side of the unit on the DIN
rail.
2) Push in the lower.
1
• Dismounting
1) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
2) Pull the lower of the unit.
3) Remove the upper hook of the unit from the DIN rail.
3
■ DIN RAIL MOUNTING (RIGHT ANGLE)
• Mounting
1) Insert the longer DIN rail mounter slider until it clicks
twice, as shown below.
2
2
1
1
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
2) Set the upper hook at the rear side of the unit on the DIN
rail.
3) Push in the lower.
2
• Dismounting
1) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
2) Pull the lower of the unit.
3) Remove the upper hook of the unit from the DIN rail.
3
■ SURFACE MOUNTING
1) Insert the two DIN rail mounter sliders until it clicks
once, as shown below.
1
2) Mount the unit with M4 screws referring the Mounting
Requirements. (Torque: 1.4 N·m)
R7G4HH-A-YVF4
3
2
1
1
EM-7777-F Rev.2 P. 5 / 9