Advertisement
MOUNTING INSTRUCTIONS
■ DIN RAIL MOUNTING (PARALLEL)
• Mounting
1) Set the upper hook at the rear side of the unit on the DIN
rail.
1
2) Push in the lower.
• Dismounting
1) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
2) Pull the lower of the unit.
3) Remove the upper hook of the unit from the DIN rail.
3
■ DIN RAIL MOUNTING (RIGHT ANGLE)
• Mounting
1) Insert the longer DIN rail mounter slider until it clicks
twice, as shown below.
2) Set the upper hook at the rear side of the unit on the DIN
rail.
3) Push in the lower.
2
Note: leave at least 10 mm (.39 in.) at the both side of the unit.
2
2
1
1
3
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
• Dismounting
1) Push down the DIN rail mounter slider with tip of a mi-
nus screwdriver.
2) Pull the lower of the unit.
3) Remove the upper hook of the unit from the DIN rail.
3
■ SURFACE MOUNTING
1) Insert the two DIN rail mounter sliders until it clicks
once, as shown below.
1
2) Mount the unit with M4 screws referring the External
Dimensions. (Torque: 1.4 N∙m)
R7F4HML3-D-DAC32A
2
1
1
EM-8002-A Rev.2 P. 4 / 12
Advertisement
