Table of Contents
Advertisement
14
UNFOLDING AND ADJUSTING LOWER HANDLE
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an
unsafe operating condition.
•
•
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
a. To raise handle assembly:
•
Pull up and back on the lower handle (1) until it is
aligned with the hole position of the arm support
and the mower housing.
•
To secure the lower handle (1) in place, lock the
lower screw (3).
•
Open the upper cam locks (2).
•
Pull up and back on the upper handle to raise it
into operating position.
•
To secure the upper handle in place, close the
upper cam locks (2).
NOTE: If the upper handle is loose or separated from
the lower handle, tighten the knobs on the upper
handle locks by turning them clockwise.
INSTALLING THE GRASS CATCHER BAG
•
Lift the rear disc harge door (1).
•
Lift the grass catc her by its handle (2) and
place under the rear disc harge door so
that the hooks (3) on the grass catc her are
seated on the door rod (4).
•
Release the rear disc harge door. When
installed correctly, the hooks on the grass
catcher will extend through the openings on
the rear disc harge door.
NOTE: When using the grass catcher, do not
install either the side discharge deflector or the
mulching plug.
Do not damage the cables when folding or unfolding the handle.
If a cable is damaged, contact an Authorized Service Dealer.
1
2
3
1
4
3
Advertisement
Table of Contents
