LawnMaster LB4010002 Instruction Manual page 23

PROBLEM
Grass jammed between the deck and
The mower does
not start.
The battery is not fully inserted in the
The mower cuts
the grass
unevenly. The cutting height is not set properly.
Wet grass clippings are sticking to the
The mower
does not mulch
properly.
The grass is too tall, or the cutting
The mower is
hard to push.
The rear of the grass catcher bag is
The mower is
excessively noisy
and vibrates.
POSSIBLE CAUSE
The battery is not charged.
The switch is defective.
blade.
mower.
Battery may require service or
replacement.
The lawn is rough or uneven.
underside of the deck.
The mulching plug is missing.
height is too low.
dragging in thick grass.
The motor shaft is bent.
The blade is unbalanced.
SOLUTION
Charge the battery.
Replace the switch
Remove battery; check under deck
for jams.
Check the connection between the
battery and the mower. Make sure
the battery clicks into place.
Replace battery.
Check the mowing area.
Move the wheels to a higher setting.
Wait until the grass dries before
mowing.
Install the mulching plug.
Raise the cutting height.
Empty the grass clippings from the
grass catcher bag.
Stop the motor, and inspect for
damage.
Repair before restarting.
23
EN