Writing To Mdt; Test Mode; Tools; Mdt Information - Kenwood KDS-100 Technical Document

4. KDS-100 Configuration
[Read]: Download the KDS-100 data to the
KPG-71D.
[Cancel]: Cancels the download and closes the
window.
An error message appears when a data transmission
failure occurs for any reason.
Note: You are required to enter your password if the data
password is set on the KDS-100.
following window will appear.
Enter your password and click [OK].

Writing to MDT

The following window appears when selecting "Write
from MDT" from the pull-down menu.
[Write]: Upload the KPG-71D data to the KDS-100.
[Cancel]: Cancels the upload and closes the
window.
Following are descriptions of each checkbox.
MDT Adjust Time: Sends the time data to the
KDS-100. The data is the same as the time
displayed on the Status bar. (The OS sets the time)
{Refer to 4.2.1.3.} You can operate the time data in
the Terminal Settings of the KDS-100.
3.4.6.}
Memory Clear: Allows you to initialise the volume
level {Refer to 3.4.2.}
{Refer to 3.4.5.}. It also allows you to delete all the
received messages that are stored in the KDS-100.
It works the same as "ALL CLR" in Reset mode, in
the KDS-100. {Refer to 3.5.1.}
An error message appears when the data transmission
failure occurs for any reason.
34
{Refer to 4.2.3.3. Others}
{Refer to
and contrast of the KDS-100

Test Mode

The following window appears when selecting "Test
Mode" from the pull-down menu.
The
This window allows you to adjust the MSK output level of
the KDS-100. Output levels should be within a certain
range to ensure stable communications between
transceivers.
Set the level from 1 to 256 by pressing ← ← ← ← and → → → → . Set
the radio input/ output level by clicking the [TX ON]/
[TX OFF] button located in the right corner of the
display. Set the input level when the button reads
[TX ON] and the output level when it reads [TX OFF].
The following display appears during Test Mode.
The value on the display changes, corresponding to the
PC's level setting. The LED flashes Green or Red when
selecting [TX ON] or [TX OFF]. In this case, you cannot
use the keys on the KDS-100 display. Click [OK] when
you finish setting the radio level. The data is written to
the KDS-100. Press [Cancel] to quit the level setting and
close the window.
Note: Select the Test (Mode) checkbox on the Others tab of
Optional Features before uploading the data to the KDS-100
for executing the Test Mode.
4.2.3.4.2} If you do not perform these operations before
executing Test mode, an error message appears when
selecting "Test Mode".

4.2.3.5. Tools

This command allows you to read the KDS-100
data, such as the model name and serial number.
It does not read the KPG-71D data.
A pull-down menu appears when selecting the
command at the Menu.

MDT Information

The following window appears when selecting "MDT
Information" from the pull-down menu.
{Refer to 4.2.3.3. Key} {Refer to