Table of Contents
Advertisement
[Page 14]
3-5-4. CYLINDER ASSEMBLY
(See Fig.3-5-7)
1)
Refer to sections 3-5-3, and remove the cylinder unit,
the rotor, and the stator.
2)
Remove the three screws (@ and the cylinder assem-
bly @.
ASSEMBLY
NOTES:
1.
Be careful not to scratch or soil the top of the cylinder.
After fitting the cylinder, clean the surface.
2.
Align the cylinder assembly @ with the two dowels @
on the mechanism chassis @).
3.
After fitting the cylinder assembly, do the tape path
adjustment as instructed in section 4-3 and do the
switching position adjustment of the servo circuit.
@ Cylinder
assembly
@ Mechanism
:
chassis
4
@D Screws
Fig.3-5-7
[Page 22]
3-14-2.
S AND T INCLINE MOUNTING
ASSEMBLIES (See Fig.3-14-2)
1)
Refer to section 3-2 and remove the mechanism unit.
2)
Refer to section 3-4 and remove the cleaner lever.
3) Remove the four screws ©) and take off the two
catcher mountings ©).
4)
Refer to section 3-1 and rotate the loading motor in
the PLAY direction until tape loading is completed.
5)
Shift the S incline mounting assembly @® slightly, in
the direction of the arrow @, then remove it from the
S load lever assembly @.
6)
Shift the T incline mounting assembly ©) slightly, in
the direction of the arrow ®,, then remove it from the
T load lever assembly ©.
ASSEMBLY
NOTES:
1.
Apply grease (VHJ-0100) to the rail (top, underside
and sides) on the mechanism chassis.
2.
When fitting the S and T incline mounting assem-
blies @) and @) into the rail, turn the loading motor
manually in the EJECT direction. When tape unload-
ing begins, watch out in case the S and T incline
mounting assemblies
() and @ get caught in the rail.
3.
Aline the dowels on the catcher mounting © with the
holes @) in the mechanism chassis.
4.
After replacing the parts, clean the cylinder and the
roller guide, then adjust the tape path as described in
section 4-3.
@$S incline mounting
assembl
@T incline
y
Ny
®
mounting
"as
assembly
me
WY
|
~
® Screws
'mene
| | © Catcher
a
he,
mounting
@S
load lever
assembly
Apply
grease
to
the top, underside
and side of the rail.
assembiy
Fig.3-14-2
Advertisement
Table of Contents
