Sanyo FISHER V95I Manual page 22

3-12-4. T SOFT BRAKE ASSEMBLY, TAKE UP REEL
1)
ASSEMBLY, T REEL GEAR (See Fig.3-12-4)
Remove the T soft spring @.
2) Remove the clamp @, then remove the T soft brake
assembly @).
3) Referto section 3-12-2 and remove the clutch mounting
assembly.
4) Pressing the T brake assembly@ in the direction of the
arrow, remove the take up reel assembly © and the T
reel gear ©.
ASSEMBLY NOTE:
1. After cleaning the shafts @ and ©, apply a drop of oil
(VHJ-0099) to each.
®Take up reel
©T reel gear assembly
@T soft brake
<«—— assembly
@T brake
assembly
Fig.3-12-4
3-13. BRAKES
3-13-1.S BRAKE ASSEMBLY, T BRAKE ASSEMBLY,
T BRAKE ACT SLIDE (See Fig.3-13-1)
1) Refer to section 3-3-1 and remove the cassette
mechanism assembly.
2) Remove the two clamps @, then remove the T brake
act slide @. (Note: You can remove the S brake
assembly @ and the T brake assembly © without
removing the T brake act slide @.)
3) Remove the brake spring @).
4) Remove the two clamps @ simultaneously, then
remove the T brake assembly ©).
5) Remove the clamp©, then remove the S brake
assembly @.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts ® and ©.
2. When fitting the T brake act slide @, align the mark @
with the shaft @.
@T brake act slide
@Brake spring
@S brake
|©
LY
A ms
y,
oS eee
"~ @Clamps
Fig.3-13-1