Sanyo FISHER V95I Manual page 12

3) Remove the clamp ©, then remove the pinion gear@.
ASSEMBLY NOTES:
1. Put the tray in the EJECT mode position before fitting
any parts.
Apply
grease
@Pinion gear
(grease
the outer rim
of the teeth)
©Drive gear \
®Lock gear Ff
(grease the outer rim
of the teeth)
@) Gear holder
Fig.3-3-3
3-3-3. DOOR OPENER, UNDER FRAME AND
STAND L (See Fig.3-3-4)
1) Remove the cassette mechanism assembly, referring
to section 3-1.
2) Remove the two clamps @ and take out the under
frame @), pulling it towards you.
3) Press down the tray lock lever @) and the lid opener
lever@), and loosen the tray©), lifting it away from you.
In this state, press the clamp © and remove the door
opener lever @).
4) Remove the two clamps@®) and take out the stand L®.
Be careful not to exert too much force on the clamps
®, as this could cause damage.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the grooves @) on the
stand L, the inside of the hole @9 in the drive shaft @,
and the mounting hole @® in the door opener lever of
the stand R.
2. Before fitting the stand L @, be sure to move the
tray © back as far as the EJECT mode position. Put the
two pins @® on the tray © into the grooves @) on the
stand L. Put the drive shaft @ into the hole @.
3. Be sure to fasten the two clamps and the clamp ©
on the stand R, and to fasten the two clamps © on
the stand L.
@Stand L
@Door opener
(Under frame
@Clamp
Fig.3-3-4