Sanyo FISHER V95I Manual page 15

3-5-2. CYLINDER (DRUM) UNIT (See Fig.3-5-5)
1)
2)
3)
4)
5)
Put the mechanism into EJECT mode.
Refer to section 3-2 and remove the VM-1/VP-1 PWB
assembly
Refer to section 3-4 and remove the cleaner lever.
Remove the two screws @ and take off the bracket @.
The bracket shape varies according to the model.
Remove the three screws@). Taking care not to
scratch or soil the tape path surface of the cylinder
(drum), lift the mounting cylinder@® slightly, and
keeping it raised.
ASSEMBLY NOTES:
1.
Apply grease (VHJ-0100) to the rails (front and rear) of
the cylinder mounting@® (grease the parts which come
in contact with the S and T incline mounting assembly).
Align the two dowels® on the mounting cylinder
) with the two holes @ on the mechanism chassis.
Check that connector is inserted in the CP-1 PWB
assembly.
After assembly, clean the tape path surface of the
cylinder (drum).
After replacing the cylinder unit, do the tape path
adjustment as instructed in section 4-3, and do the
switching position adjustment of the servo circuit.
@Screw
@Cylinder
mounting
Connector on the
CP-1 PWB assembly
Fig.3-5-5
according to model)
Pi \ (Bracket (shape varies
3-5-3. CYLINDER MOTOR (ROTOR AND STATOR)
1)
2)
3)
4)
(See Fig.3-5-6)
Refer to section 3-5-2 and remove the cylinder unit.
If you have removed the mechanism unit, remove the
screw (1) and remove the cylinder earth assembly @.
Remove the two screws@), the rotor® and the
spacer @).
Remove the three screws () and the stator ©.
ASSEMBLY NOTES:
1.
©Stator
(®)Spacer
When fitting the rotor@, align the long hole@ -beside
the triangular mark on the rotor® - with the hole
in the rotor disk.
When fitting the screws@ and ©, use the torque
gauge screwdriver (VHJ-0014). give the screws a
tightening torque of 3 kg/cm.
Align the dowel @ on the cylinder earth assembly @
with the hole @2 in the chassis.
If you have removed the cylinder unit, after assembly,
do the tape path adjustment as instructed in section
4-3, and do the switching position adjustment of the
servo Circuit.
@ Screws
@Long hole (used for
alignment when fitting
the rotor)
(Cylinder
earth
assembly
~
| as
oh
@ Hole
Hole (use for alignment
when fitting the rotor)
Fig.3-5-6
=43=