Sanyo FISHER V95I Manual page 19

3-9-2. PINCH LIFT CAM AND PINCH CAM GEAR
1)
2)
3)
4)
5)
(See Figs.3-9-2 and 3-9-3)
Refer to section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
Refer to section 3-9-1 and remove the pinch roller
lever assembly.
After removing the screw), undo the three clamps®),
then remove the opener mounting @.
Remove the clamp @ and the pinch lift cam ©.
Remove the pinch cam gear ©.
ASSEMBLY NOTES:
1.
@Opener
mounting
©Pinch cam gear
Apply grease (VHJ-0100) around the shaft @, all over
the teeth ® of the pinch cam gear ©), all over the
teeth of the pinch lift cam ©, all over the cam grooves
@), and all over the "V Part©" of the opener mounting
@). Apply grease (VHJ-0101) to the outside of the
shaft ® and all over the top cam © of the pinch cam
gear ©.
Check that the positioning mark@® on the mode
switch @ is aligned with the arrow@) onthe MC-1 PWB
assembly, as shown in Fig.3-9-3. Then align the
triangular mark @ on the pinch cam gear © with the
arrow @) on the MC-1 PWB assembly. After that,
align the round hole @ on the pinch lift cam © with
the indentation @ on the pinch cam gear ©.
If you have carried out the above alignments and the
pinch roller will still not move up and down or perform
the pressing movement correctly, refer to section
3-15 and check the alignment of the gear wheels 1
and 2, the main cam, and the mode switch.
«<— @Screw
OV" part
—_—_—— >
@Clamps
®o—~> @®Shaft
Fig.3-9-2
(Arrow on MC-1 PWB
Ley.
assembly
$ @Positioning marks
é)
on mode switch
©)Pinch lift cam
@Triangular mark (Round hole
@Mode switch ©Pinch cam gear
Fig.3-9-3
LAT x