Capstan Motor - Sanyo FISHER V95I Manual

3-7. CAPSTAN MOTOR
3-7-1. CAPSTAN MOTOR (See Fig.3-7-1)
1) Refer to section 3-2, then remove the mechanism unit.
2) Remove the two screws @), then remove the harness
mounting @.
3) Remove the reel belt @.
4) Remove the three screws©® and the capstan motor ©.
ASSEMBLY NOTES:
1. Check that connector @ is inserted in the CP-1 PWB
assembly.
2. When fitting the three screws©®, use the torque
gauge screwdriver (VHJ-0014). Give the screws a
tightening torque of 3.5 kg/cm.
3. After assembly, clean the capstan shaft with a soft
cloth or chamois.
®©Screws
S— ©Capstan
motor
@)Reel belt
Fig. 3-7-1
3-7-2. CAPSTAN BRAKE ASSEMBLY (See Fig.3-7-2)
1) Remove the spring @.
2) Remove the clamp ®, then remove the capstan brake
assembly @).
@Spring
Wy
oe:
@Capstan brake ——> Y,
assembly \
<<
—~15—