Table of Contents
Advertisement
3-13-2. BRAKE CONTROL LEVER AND BRAKE ACT
LEVER ASSEMBLY (See Fig.3-13-2)
1)
Refer to section 3-2 and remove the mechanism
unit.
2)
Refer to section 3-15 and remove the wheel gear 2.
3)
Refer to sections 3-12-1, then remove the reel belt and
the reel pulley.
4)
Remove the clamp), then remove the wheel gear 1@).
5) Remove the clutch change spring @.
6) Remove the clamps @ and ©), then remove the brake
control lever®. Remove the clamp @ on the topside
of the mechanism chassis.
7) Remove the brake return spring @.
8)
Refer to section
3-8 and
remove
the worm
gear
assembly.
9) Remove the clamp@® and clamp ©), then remove the
brake
act
lever
assembly@.
To
maintain
the
performance of the brake act lever assembly @), do not
disassemble it.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts @® and @, to the
teeth of the wheel gear 1 @), and to the pin @ of the
brake control lever ©.
2.
Putthe pin@® of the brake control lever © into the cam
groove (4 of the crescent slide.
3.
Before fitting the wheel gear 1 ©, align the hole @
with the hole @® on the mechanism chassis.
4.
Refer to section 3-15 and align the wheel gear 2.
@Pin
©Brake controllever
¢
@Clutch change
rH
spring
fHxe
a
G
ESS
7 @arake act
lever
|
:
@Clamp—s
S
2~~
assembly
|
te @Brake return
@®Hole|
@
spring
@Clamp
Sy
|
@)Wheel
(EE) SN
St
@Clamp
gear 1
l
| @Cam
<>
\
roove
ey)
i=
Aa
"its
®Clamp
@Shaft
. ae
@Shaft
(Hole oo
Fig.3-13-2
—2?1—-
3-13-3.S BRAKE ACT SLIDE AND BT SPRING LEVER
ASSEMBLY (See Figs.3-13-3 and 3-13-4)
1)
Refer to section 3-16 and remove the crescent slide.
2)
Refer to section 3-12-1 and remove the friction gear
assembly.
3)
Slide the S brake act slide @ in the direction of the
arrow (A), then remove it.
4)
Refer to section 3-11 and remove the BT spring.
5)
Press the BT spring lever assembly © until it touches
the pin @, then remove it.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shaft @ shown in Fig.
3-13-3, and to the BT spring lever assembly@ and
the S brake act slide @ shown in Fig.3-13-4.
2.
After mounting the BT spring lever assembly® on the
Shaft @, hook the BT spring onto the clamp © and
press it until it touches the pin ©.
3.
Make sure that the clamps @, ®) and @ have snapped
into the S brake act slide @. Align the arrow @ on
the S brake act slide @ with the arrow @) on the
mechanism
chassis.
@)Arrow on mechanism chassis
(BT spring
lever
assembly
@S brake act slide
2 ss
oe
Fig.3-13-3
Apply grease
» (BT spring
<— lever
assembly
Apply grease
Fig.3-13-4
Advertisement
Table of Contents
