Reel Drive Mechanism - Sanyo FISHER V95I Manual

3-12. REEL DRIVE MECHANISM
3-12-1. REEL BELT, REEL PULLEY, FRICTION GEAR
1)
2)
3)
4)
5)
6)
ASSEMBLY AND CLUTCH CHANGE LEVER
(See Fig.3-12-1)
Refer to section 3-2 and remove the mechanism unit.
Remove the reel belt @ from the reel pulley @.
Take off the washer @ and remove the reel pulley @.
Take off the washer @ and remove the friction gear
assembly ©).
Remove the clutch change spring ©.
remove the clamp@® gripping the top of the
mechanism chassis, then remove the clutch change
lever 8).
ASSEMBLY NOTES:
1.
2.
©Clutch change
After cleaning the shafts @ and @, apply a drop of oil
(VHJ-0099) to each.
Be careful not to get any grease on the reel belt@.
LOSS @)Reel belt
€<— @Washer
spring
pe |
@®Clutch change lever
©@< @Washer
<—(©Friction gear
: assembly
Fig.3-12-1
3-12-2. CLUTCH MOUNTING ASSEMBLY
(See Fig.3-12-2)
1) Refer to section 3-3-1 and remove the cassette
mechanism assembly.
2) Refer to section 3-12-1 and remove the reel pulley.
3) Remove the two screws @), then remove the clutch
mounting assembly @.
ASSEMBLY NOTES:
1. Align the two holes @ with the shafts @ and ©. Be
careful not to press part A of the clutch mounting
assembly () against the band brake assembly.
2. After assembly, make sure that the clamp on the
clutch change lever has snapped into the chassis.
Screws
a ®
PartA {
mounting
assembly
Fig.3-12-2
3-12-3.S SOFT LEVER, SUPPLY REEL ASSEMBLY
AND S REEL GEAR (See Fig.3-12-3)
1) Remove the S soft spring ®.
2) Remove the clamp @), then remove the S soft lever@).
3) Referto section 3-12-2 and remove the clutch mounting
assembly.
4) Refer to section 3-11 and remove the band brake
assembly, then remove the supply reel assembly @)
and the S reel gear ©.
ASSEMBLY NOTES:
1. After cleaning the shafts © and @, apply a drop of oil
(VHJ-0099) to each.
2. After assembly, clean the side of the supply reel
—~19—
assembly @).
@Supply reel
assembly
@S soft lever
©Shaft
ok
Fig.3-12-3