Table of Contents
Advertisement
7.2 Operating mode 'Auto Run Mode'
7.3 Operating mode 'Sound Mode'
A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
1.
Press [Mode], use [Up] and [Down] to select the menu option 'Auto Run Mode' and con‐
firm with [Setup].
2.
Use [Up] and [Down] to set the programme running speed in a range from '001' ... '100'
(slow ... fast) and confirm with [Setup].
3.
Use [Up] and [Down] to set the flashing speed for the strobe effect in a range from '001'
... '100' (slow ... fast) and confirm with [Setup].
4.
Use [Up] and [Down] to set the number of runs in a range from '001' ... '100'
(slow ... fast) and confirm with [Setup] to exit the menu.
This setting is only relevant if the device is working as Slave in a Master / Slave configuration
and is not controlled via DMX. In this operating mode, the device responds to acoustic pulses
which are recorded by the integrated microphone.
Operating
xBrick Quad 16×8W RGBW
29
LED Floodlight
Advertisement
Table of Contents
