7
Operating
7.1 Starting the device
7.2 Main menu
DMX address
DMX mode
Connect the device to the power supply to start operation. The display shows 'A001' for a few
seconds, then the device is ready for operation.
This setting is only relevant if the device is controlled via a DMX controller.
Press [MODE] repeatedly until 'Addr' appears in the display. Press [ENTER], then use [UP] and
[DOWN] to select the desired DMX address between 1 ( 'A001' ) and 512 ( 'A512' ) and confirm
with [ENTER].
This setting is only relevant if the device is controlled via a DMX controller.
Press [MODE] repeatedly until 'Chnd' appears in the display. Press [ENTER], then use [UP] and
[DOWN] to select the desired DMX mode (2CH1, 2CH2 or 11CH) and confirm with [ENTER].
Wild Wash 9x3W LED UV BK DMX 9x3W LED UV WH DMX
Operating
23